Fixing a broken toilet requires a professional plumber; however, a few times when DIY toilet fixing can be done. You just need a few DIY skills for that. Following are six ways to fix a broken toilet, have a look:
6 Ways to Fix Broken Toilet
- Fixing a Clogged Toilet
The most common issue with toilets is a clogged toilet. This issue may originate either due to excessive water flow or flushing down too much material. Whatever might be the case, there are a few options for clearing out the clog. One of the best tools for this purpose is a plunger; however, choosing the right one is necessary. Push the plunger slowly as it will the first remover the air moving, and you will avoid splashing of dirty water on yourself. If you do not get the result after pumping the plunger a few times, mix baking soda and vinegar. This is a non-toxic solution that helps in keeping drains run smoothly. And if this trick also fails, then buy a plumbing snake and use it to avoid scratching or damaging your toilet.
- Ballcock Replacement
Is your toilet running? Then the culprit might be the ballcock! A ballcock is a hollow ball that floats at the top of the water in your tank. It is responsible for operating the valve that keeps the water flowing and stopping. When the water is drained from the tank, the ball drops down. As the water gets filled in the tank, the ball raises, and the valve is connected to gets closed. If the water continues to run, then it indicates that the ballcock is not calibrated correctly. You can get pent the float arm for shutting off the tank or fine-tune the quantity of water you are using in your tank. The best way out is to replace the ballcock with a modern float-cup valve to avoid fixing this issue.
- Issues with Flush Valve
Is the flush valve throwing tantrums? Take a closer look at it. The flush valve is a brass or plastic fitting located at the center of your tank attached to the opening. There is a flapper that is accountable for emptying water and keeping it in the tank. The overflow tube prevents the water from overflowing into the tank. If any of these components aren't working correctly, then it could cause the water to run.
- Continuously Running Toilet
Is your toilet running always? Or do you need to waggle the handle often? Then the problem might be with the flapper. Here, it is necessary to completely seal the flush opening for keeping the tank run slowly. If the water in your tank runs too high, water flows into the overflow tube and is sent back into the tank. You can adjust the refill valves for changing the water level. If required, replace the flapper valve.
- Loosened Flush Handle
A loosened flush handle can be a great hassle if not fixed on time. You will need to open up the tank and check the lift wire or chain for selecting it. In most cases, the lift chain gets tangled, bent, or broken, causing the handle to loosen up. The broken chain can be temporarily fixed with a paper clip. And if the mounting nut of the handle inside the tank is loose, you need to turn the nut and secure the handle to its location on the side of the tank.
- Leaking Toilet Base
Some issues occur outside the bowl as well. However, before diagnosing the problem, consider the season due to humidity and condensation, some tanks appear leaky. However, if there is a puddle seen at the base of your toilet, be careful else you might have to deal with the dirty and contaminated water. A wax ring seals the bottom of the bathroom to the drain opening below. Remove the toilet to fix the problem, and for this, hire a professional plumber.
Conclusion:
If you find fixing the toilet too intense, then it is high to call a plumber. With mobile apps like ChoreRelief, you can easily find out the best and background checked plumbers in and nearby your area. To know more about the app, visit https://chorerelief.com/
No comments:
Post a Comment